Try the following steps, in this order, until the telescopes are in a safe position, i.e. approximately horizontal.
* Run the command ''<tt>slew stow'' </tt> in any terminal window on the TCS machine (computer keyboard/screen nearest the door). The username/password is written on the white board. * If this command does not work, try the command "<tt>park" </tt> in any terminal window. * Check that the telescopes are out of the way of the roof. If not, use Use a 13mm spanner to loosen-off the RA and Dec drive clamps and move the telescopes to a safe position by hand. Remember to tighten (but don't over-tighten) the drive clamps afterwards. There is a tool box on the floor in the mount room.
==== Close the roof ====
Try the following steps, in this order, until the roof is closed.
* On the observer machine, enter the command "<tt>close_roof" </tt> in any terminal window. (Same username/password as tcs).
* If this does not work, use the grey box on the wall of the computer room to close the roof.
# Press "START" to power-up the hydraulics
# Press "STOP" to shut-down the motor.
# Twist the STOP button to release it when you have finished.
* ''In an emergency only'' e.g. if there is no power, you can use the spanner next to the box WEATHER STATION POWER SUPPLY to undo the 3 bolts that hold the roof onto the hydraulic ram and push the roof closed by hand (this . '''This is a two-person job). Created to document the systems last resort and will require at the SuperWASP telescopeleast two people'''.
==Fault Reports==
[https://faultreports.saao.ac.za/index.php?board=9.0 SuperWASP Fault Reports]