== How to close the roof without breaking the telescopes ==* Park the telescopes using the command "slew stow" in any terminal window on the TCS machine (computer keyboard/screen nearest the door). The username/password is written on the white board. If this command does not work, try the command "park". * Check that the telescopes are out of the way of the roof. If not, use a 13mm spanner to loosen-off the RA and Dec drive clamps and move the telescopes to a safe position by hand. Remember to tighten (but don't over-tighten) the drive clamps afterwards. There is a tool box on the floor in the mount room. * On the observer machine, enter the command "close_roof" in any terminal window. (Same username/password as tcs).* If this does not work, use the grey box on the wall of the computer room to close the roof. Press "START" to power-up the hydraulics, the hold the "CLOSE" button until the roof is closed. Press "STOP" to shut-down the motor. Twist the STOP button to release it when you have finished.* In an emergency only, and if there is no power you can use the spanner next to the box WEATHER STATION POWER SUPPLY to undo the 3 bolts that hold the roof onto the hydraulic ram and push the roof closed by hand (this is a two-person job).
==== First put the telescopes in a safe position ====
Created Try the following steps, in this order, until the telescopes are in a safe position, i.e. approximately horizontal.* Run the command <tt>slew stow</tt> in any terminal window on the TCS machine (computer keyboard/screen nearest the door). The username/password is written on the white board. * If this command does not work, try the command <tt>park</tt> in any terminal window. * Use a 13mm spanner to document loosen-off the systems at RA and Dec drive clamps and move the SuperWASP telescopetelescopes to a safe position by hand. Remember to tighten (but don't over-tighten) the drive clamps afterwards. There is a tool box on the floor in the mount room. ==== Close the roof ====Try the following steps, in this order, until the roof is closed. * On the observer machine, enter the command <tt>close_roof</tt> in any terminal window. (Same username/password as tcs).* If this does not work, use the grey box on the wall of the computer room to close the roof. # Press "START" to power-up the hydraulics# Hold the "CLOSE" button until the roof is closed# Press "STOP" to shut-down the motor. # Twist the STOP button to release it when you have finished.* ''In an emergency only'' e.g. if there is no power, you can use the spanner next to the box WEATHER STATION POWER SUPPLY to undo the 3 bolts that hold the roof onto the hydraulic ram and push the roof closed by hand. '''This is a last resort and will require at least two people'''.
==Fault Reports==
[https://faultreports.saao.ac.za/index.php?board=9.0 SuperWASP Fault Reports]