Changes
/* Troubleshooting */
7. '''The telescope won't slew'''. First check that the telescope is unparked and that the target is within the visibility window. If those things are fine, the telescope may have triggered the hardware azimuth limit switch. This sometimes happens if the telescope is at azimuth ~165. Go to the SiTechExe GUI (the long, thin one) and at the top of the Scope tab, check if any of the arrows are red or orange. If they are, click the opposite arrow a few times to move the telescope out of the limit. If the motors are in "blinky", you may need to click the button at the bottom to switch the motors to automatic.
8. '''Telescope motors are in "blinky" mode and won't switch to auto.''' There is likely an error on the alt and/or az controller board which will need to be reset. Find the SiTechExe GUI (the long, thin one) and try pressing the button at the very bottom to switch the motors to Auto. If it does nothing, select the "Features" tab on the same GUI. Press the "Controller Stuff" button, which will open the "Controller Information Window". There are two columns in this GUI, one for alt, one for az. There is a text box about two-thirds of the way down each column, which will either say "No Errors", or list some errors. If there is an error in the box, click the "Reset Errors" button directly underneath that text box. '''Be very careful not to click any other button.''' If that has fixed the problem, the button in the top left corner will say "To Manual (Blinky)" and you can close the Controller Information Window and resume operations.
