Changes
/* Troubleshooting */
8b) If 8 & 8a) don't solve the problem, close all SiTech software and reset the SiTech altaz controller under the North pier, then restart the SiTech software. If the motors aren't in Auto and can't be switched to Auto on startup, check for errors as per point 8 above.
9. '''North-South on the image is not aligned with columns on the instrument detector.''' On the SiTech rotator GUI, on the "Config Page 1" tab, there are two boxes that need to be ticked to keep North aligned with either "up" or "down" on the detector. Tick these two boxes on the SiTech Right Rotator Control GUI for Mookodi, or the Left Rotator for Sibonise:
- "Track PA (Parallactic Angle) (Keep North Up)"
- "If PA is out of range, Track PA+-180"
